Skip to content
Home » News » Commissioning Tips for Leveling, Flattening and Straightening Machines

Commissioning Tips for Leveling, Flattening and Straightening Machines

  • JIUZH 

The leveling machine is used for coil leveling and feeding. School leveling machine stereotypes mainly depends on the material to be school leveling machine, thickness and the requirements of the material, also known as correction machine, leveling machine, placed in the material frame (or cut welder) and feeder between the commonly used equipment in the processing of plate, the greater the structural rigidity required, the fewer the number of rolls, the greater the roll diameter, the greater the power (width of a certain), and vice versa.
Leveling machine due to leveling material thickness is divided into thick plate leveling machine, material leveling machine, precision leveling machine, precision thin plate leveling machine, ultra-precision leveling machine and so on several different specifications and models, in fact, the operation of the leveling machine and the adjustment method are the same, the following, I would like to introduce you to the leveling machine straightening skills:

In general, the school leveling machine equipment has been debugged before leaving the factory according to customer requirements, but the equipment is limited to this fine-tuning:
First, the plate from the school leveling machine traction roller direction inverted into the leveling, out of the board depending on the school leveling degree of fine-tuning of the leveling effect;
Second, if the plate appears upward phenomenon, you can make it upward rotation 1-2 circles, appropriate adjustment of the rear handwheel of the leveling machine;
Third, such as the plate appears downward phenomenon, can make it downward rotation 1-2 circles, appropriate adjustment of the rear handwheel of the leveling machine;
Fourth, if the plate uneven phenomenon, you can adjust the front handwheel of the leveling machine, make it rotate downward 1-2 turns, the rear handwheel should be rotated downward at the same time 1-2 turns;

Fifth, if the plate appears lateral warping phenomenon, you can properly adjust the support roller adjusting bolt on the leveling machine, the middle of the support roller upward loosening 1-2 turns, the left and right two support rollers to adjust 1-2 turns;
Sixth, such as plate transverse downward bending phenomenon, can be appropriate to adjust the leveling machine on the support roller adjusting bolts, the middle of the support roller downward loosening 1-2 turns, the left and right sides of the upward adjustment of 1-2 turns;
Seven, the cylinder pressure of the traction roller of the leveling machine should be adjusted to 2-2.5MPa to prevent indentation caused by the pressure plate.

Leave a Reply

Your email address will not be published. Required fields are marked *

EN
× How can I help you?