Skip to content
Home » News » How to commission a leveling machine

How to commission a leveling machine

  • JIUZH 
  1. First cut a length of about 1.5 meters of the material required for the debugging of the leveling machine.
  2. Correct the material curvature before the leveling of the direction of divergence, sent to the leveling machine (i.e., inside down, outside up).
  3. Leveling machine out, the material curvature ends upward and downward, should be adjusted to adjust the leveling handwheel, so that the upper leveling roller to rise.
  4. When the material out of the leveling machine is wavy, should adjust the leveling handwheel, (1) so that on the leveling roller up (2) before and after the roller is too large, should be adjusted appropriately.
  5. When the curvature of the material out of the leveling machine is still down at both ends and up in the middle, the leveling handwheel should be adjusted so that the upper leveling roller is pressed downward.
  6. After the leveler comes out, the material runs to one side, the leveling adjustment handwheel should be adjusted so that the leveling roller on the side of the running material rises.
  7. When adjusting the leveling roller, it should be noted that the left and right adjusting handwheels should be adjusted synchronously.
  8. To achieve good leveling effect, you need to make the leveling roller tilt upward from feeding to discharging.

Leave a Reply

Your email address will not be published. Required fields are marked *

EN
× How can I help you?