Skip to content
Home » News » How to commission a sheet metal leveler?

How to commission a sheet metal leveler?

  • JIUZH 
  1. Pour the plate from the direction of the plate leveling machine traction roller, out of the plate to stop fine-tuning the flatness of the plate.
  2. Assuming that the plate is warped, you can properly adjust the plate leveler after the handwheel upward rotation 1-2 turns.
  3. Assuming that the plate is bent, you can properly adjust the plate leveler after the handwheel downward rotation 1-2 turns.6
  4. Assuming that the plate calibration is not uniform, the front hand wheel of the plate leveler can be appropriately adjusted to rotate downward for 1-2 turns, and the rear hand wheel should be rotated downward for 1-2 turns at the same time.
  5. Assuming that the plate is transversely upward, the support roller adjusting bolt on the plate leveler can be adjusted appropriately; the left and right bolts should be adjusted 1-2 turns downward, and the middle support roller should be loosened upward by 1-2 turns.
  6. Assuming the phenomenon of transverse downward bending of the plate, the support roller adjusting bolt on the plate leveling machine can be adjusted appropriately, the left and right bolts are adjusted upward by 1-2 turns, and the middle support roller is adjusted downward by 1-2 turns.
  7. Adjust the cylinder pressure of the traction roller of the plate leveling machine at 2-2.5MPa to avoid excessive pressure on the plate causing indentation.

Leave a Reply

Your email address will not be published. Required fields are marked *

EN
× How can I help you?