Skip to content
Home » News » Manufacturers explain: how to use the straightening machine to straighten the deformed plate

Manufacturers explain: how to use the straightening machine to straighten the deformed plate

  • JIUZH 

Deformation plate is deformed metal plate, general deformation of steel plate can not be used, we need to correct the deformation of iron plate to use, deformation of steel plate is relatively hard, manually, there is generally no way to operate, so generally use some leveling equipment to correct the deformation of steel plate, the application of more should be considered as a steel plate leveling machine, next we will learn how to use the leveling machine to correct the deformation of steel plate.

1, the thinner zero plate correction should be, with a thicker steel plate as a pad, on the zero plate for correction, can also be several long thin plate stacked into the correction.
2, the center of the flat and the edge of the wavy plate correction, can be in the middle of the flat parts of the pad, so that the middle of the thinning and elongation to the edge of the same length, and arrive at the intention of correction.
3、Steel plate leveling machine in the middle of the longitudinal wavy and the two ends of the correction of the flat plate, can be added at both ends of the pad, so that the two also thinning, stretching and the center of the length of the corrective intent.
4, one side is wavy, the other side for the correction of the flat plate, the flat side can be added in the pad, make it thin and elongated, and the wavy side of the length of the board will be corrected. This plate can also be in the leveling side of the direct pressure, so that this side of the stretching thin, and make the two ends of the length, the plate can be corrected.

This article describes how to use a straightening and profiling machine to correct a warped plate. After correction, the bent deformed plate can be used. In fact, not only deformed plates, but also some other plates need to be straightened. Of course, in addition to using a straightening machine for correction, a shaping machine can also be used. In fact, their functions are more or less the same.

Leave a Reply

Your email address will not be published. Required fields are marked *

EN
× How can I help you?