Перейти к содержимому
Home » News » How to commission a leveling machine

How to commission a leveling machine

  • JIUZH 
  1. First cut a length of about 1.5 meters of the material required for the debugging of the leveling machine.
  2. Correct the direction of divergence of the curvature of the material before the leveling raised, sent to the leveling machine (i.e., the inner side down, the outer side up).
  3. Leveling machine out, the material curvature ends upward and downward, should be adjusted to adjust the leveling handwheel, so that the upper leveling roller to rise.
    Выравниватель
  4. When the material coming out of the leveler is wavy, the leveling handwheel should be adjusted (1) so that the upper leveling roller rises (2) the front and rear rollers are too large, and should be adjusted appropriately.
  5. When the curvature of the material out of the leveling machine is still down at both ends and up in the middle, the leveling handwheel should be adjusted so that the upper leveling roller is pressed downward.
  6. After the leveler comes out, the material runs to one side, the leveling adjustment handwheel should be adjusted so that the leveling roller on the side of the running material rises.
  7. When adjusting the leveling roller, it should be noted that the left and right adjusting handwheels should be adjusted synchronously.
  8. To achieve good leveling effect, you need to make the leveling roller tilt upward from feeding to discharging.

Добавить комментарий

Ваш адрес email не будет опубликован. Обязательные поля помечены *

RU
× Могу я чем-нибудь помочь?