Перейти к содержимому
Home » News » Maintenance inspection and operation precautions of perforated mesh plate straightening and leveling machine

Maintenance inspection and operation precautions of perforated mesh plate straightening and leveling machine

  • JIUZH 

The main work content of the leveling unit during maintenance is to pay attention to lubrication, tightening and inspection. Due to the level of work directed by the head of the mechanical components and cleaning and maintenance group, the operator of the leveling unit should focus on checking and adjusting the reducer and gear transmission mechanism, straightening equipment and electrical system, and then make the necessary adjustments. If faults are found, make sure the mechanical components and parts have good working performance.

The use of professional instruments unit test, mainly can test and adjust the steel plate straightening leveling unit, troubleshooting the problems of each part, balancing the degree of wear and tear, will inevitably affect the performance of each part and the diagnosis and inspection of fault symptoms. Some countries test, and then complete the necessary replacement, adjustment and troubleshooting work after the third level of maintenance requires technical integrated service personnel and advanced testing instruments and tools.
Tension controller on the leveling unit will also be set according to the detection of slitting and winding speed and diameter, load torque, tension and other calculation parameters, tension control can output standard 0 to 10v, and then sent to the inverter through the analog signal, which should pay attention to the selection of the given torque. Also because of this, the mechanical operation process can also maintain a constant tension, deceleration work in order to make the working conditions stable.
Steel plate leveling machine in operation, flat pressure leveling technology to remove the unit of material, that is, to eliminate the pressure of the material. For the level of the plate, the basic principle of roll leveling is to pay attention to the choice of material elastic extension, the yield point of the lower part of the material, so that the “fiber” part in the short ratio of scalability to obtain the “fiber length”.

Добавить комментарий

Ваш адрес email не будет опубликован. Обязательные поля помечены *

RU
× Могу я чем-нибудь помочь?